R/C PLANES
TRAINERS
EZI-FLI
This model
plane requires assembly and comes as a kit of laser-cut balsa parts. An ideal
introduction to R/C flight for teaching building techniques and learning to fly
with this 1060mm wingspan high wing trainer. Kits are manufactured in Australia
and there are two versions.
MP09: EZI-FLI kit
only
MP10: EZI-FLI kit with SH15 R/C motor
All
airframe parts available.
NAVIGATOR 25
This ARF
kit is an ideal beginners model requiring minimum construction to complete.
Its large wing area and light weight make it easy and forgiving to fly.
Controls are conventional 4 channel with throttle, ailerons, elevator and
rudder.
Wingspan: 1220mm Length: 880mm
Wing Area: 26.8dm2 Weight: 920g
Motor: 2C-3.5cc
Radio Gear: 4 channel, 4 servo
LM NAVIGN25 - ARF
25 size Trainer
Accessories: SC SS300 Standard
Servo 2.7kg/cm
CESSNA 206T
Great 4
channel RTF
Trainer that is easy to fly and has plenty of power from the Brushless motor
system for aerobatics. Minimal assembly, constructed from foam it has ailerons,
elevator, rudder and steerable nose wheel. Flaps and servo cutouts are moulded
into the wing. Includes 4 ch 36MHz FM Radio system and all gear is
pre-installed. Also has 7.4V 1800mAh LiPo and 12VDC LiPo charger. Flying weight
610g
Wingspan: 1080mm Length: 980mm
Radio Gear: 4 CH, ailerons, elev,
rudder/nose wheel & throttle
MX CESSNAM1
Cessna RTF mode1 TX
MX CESSNAM2
Cessna RTF mode2 TX
Spare Parts: Some
listed below for example.
MX CESSBATT LiPo 1800mHa 7.4V MX CESSCBAT Battery Case MX CESSCHAR
LiPo Charger
MX CESSCOWL
Engine Cowl MX CESSMOUNT
Engine Mount MX
CESSESC Speed Cont
MX CESSFUSE Fuselage MX CESSLAND Landing Gear MX CESSMOTOR B/less Motor MX CESSPROP 8x6 Propeller MX CESSVTAIL Tail Fin MX CESSWING
Wing